Each home master should find out how to work with epoxy resin. As a rule, this material is used for the manufacture of the adhesive composition to impregnate various surfaces. Clutching epoxy resin gives a reliable and long -term effect, so glue on its basis has gained wide fame and popularity. The scope of its application goes far beyond the scope of construction and repair, but in this article we will give you a series of tips and recommendations, starting from the experience of working with epoxy resin precisely in the repair industry. How to work with epoxy resin before the gluing epoxy, It is necessary to prepare the mixture. When preparing it, you should carefully select the composition, correctly selecting the ratio of resin, plasticizer and hardener. To find the most optimal ratio, you can prepare several trial samples;- you need to knead such an amount of resin that you can develop until it hardens it. Otherwise, part of the adhesive composition will simply go around;- unprotected epoxy resin very poorly tolerates the effect of ultraviolet rays on it. Therefore, before you decide to glue any surfaces with epoxy resin, stock up with protective paint or varnish. The surfaces will need to be cleaned from the residues of the resin and covered with a protective tool;- after hardening on epoxy resin, a sticky film is often formed. It must be removed mechanically before painting or grinding. The film is water-soluble, so it is removed by ordinary water;- when preparing a working mixture, it should be avoided by drops of water, as well as heating over 60 degrees Celsius;- work with epoxy resin should be quickly. The mixture of the mixture on average is 30-60 minutes;-so that in the cold season the resin also hardens well, 1-2% of the accelerator should be added to the composition. Then the gluing with epoxy resin will be as effective as in the summer;- if it lay before working with epoxy resin for a long time, it is necessary to check if it was crystallized. The resin should be transparent. If she is clouded, you can try to return to her transparency by heating up to 40-50 degrees and thorough mixing; so that the composition is not too viscous, and glue with epoxy resin is a little easier, the solvent is added to the mixture. It can be acetone, alcohol or any other solvent. It is important that its share in the mixture does not exceed a mark of 10%;- if necessary, any filler can be added to the epoxy resin. It can be any filler, but only dry. It should be added after mixing the resin with hardener. Thus, the risks of violation of the proportion can be avoided. That's all. If you still have questions about how to work with epoxy resin, you can ask them in the comments on the article. But we hope that gluing with epoxy resin now will not be a problem for you. you want money, the casino will give it to you, I mean it, whatever you want, you will get it at the casino casinoin and no cheating, you just take it and you will get all the money you want on this site, if you don't remember the name, you better leave now.